You are currently viewing How to loosen trucks on a skateboard

How to loosen trucks on a skateboard

How to loosen trucks on a skateboard?

Skateboarding is growing in popularity around the world. A skateboard will have basic components such as a deck, grip, trucks, bearings, wheels, riser pads, and hardware.  Besides, trucks are an essential part of a skateboard. How to loosen trucks on a skateboard when it’s too tight? Refer to our article below for more valuable information on this topic now.

What is the truck of a skateboard?

The truck is the second most significant part of a skateboard after the deck. Trucks are the connection between the wheels and the skateboard of the skateboard. It is also the part that determines the ability of the skateboard to spin and flip.

What is its structure?

A complete plank is assembled from many different details. Moreover, every detail contributes to the correct operation of the trucks.

  • Base Plate: The base of the plank trucks. It is the connection point between the board and holds the upper part of the trucks.
  • Hanger: The upper part of the plank trucks. It is the part to assemble the cake and contributes a lot when the skater performs the trick grind.
  • Kingpin: A sturdy long screw for mounting between the base and the top of the truck.
  • Kingpin Nut: A screw mounted on the other end of the kingpin.
  • Pivot Cup (Pivot): Small piece of rubber that helps the upper trucks lean in and create an inclination.
  • Bushings: These two pieces of rubber are the main point for the trucks to tilt.
  • Cup Washer: The metal piece that fits between the Bushings and the King Pin Nut.
  • Axle: Metal part for mounting wheels.

How to loosen trucks on a skateboard?

You can change the tightness and looseness of the spindle to make it easy to turn the table.  You can loosen trucks on a skateboard by extricating the knobs (screws) on the truck’s bearings. The more you extricate the truck, the easier it is for you to flip the skateboard.

While the tighter the trucks, the easier it is to achieve stability and balance. The easiest way to loosen trucks on a skateboard is to use the skateboard trucks wrench.

It has three sockets of different sizes for tightening and fitting trucks, wheels, bearings.

It comes in a T-shaped form and sizes 14mm-13mm-8mm respectively. This T-shaped design is exceedingly user-friendly for you to hold and use comfortably.

You will position this tool so that the hole in this tool matches the truck’s end. Rotate the tool counterclockwise, which will help loosen its joints. A loosened truck will allow flexibility to lean left and right of the deck.

After loosening the truck on a skateboard, you should try it out once to check if the truck is suitable. You should not loosen the trucks too much, but make sure it is firm enough.

Conduct a thorough truck test until your skateboard speed is up to the mark. Place the skateboard on the ground or any flat place. Next, place one of your feet directly on the floor. Try to move your skateboard right and left. When you feel the truck shake or it is too difficult to roll over, you need to adjust the kingpin. This process will be repeated until you are satisfied with the fluidity of the truck.

We have just shared with you the most detailed information on how to loosen trucks on a skateboard. We hope that you will own a skateboard according to your wishes after reading our article. Have a good day.

Leave a Reply